Drone parts that pass the sourcing audit.

Airframe fittings, motor mounts, gimbal housings, payload enclosures and harnesses for drone and counter-UAS programs. We source from vetted domestic vendors and document where every part was made. One project manager stays with your program from the first 50 units to the next 5,000.

How we review it

Your project manager and a technical lead review every print within 24 hours. For UAS work we flag weight and wall thickness risks, confirm material and finish callouts, and route the job to a domestic shop sized for your volume, whether that is a prototype lot or a production run.

Quality + Compliance

AS9100D Compliant · ISO 9001:2015 · ITAR Registered · NIST 800-171 Compliant · Domestic sourcing

What we source

Matched to domestic shops sized for your volume.

Airframe fittings
Machined aluminum, light and stiff.
Motor mounts + arm tubes
Milled and turned to print.
Gimbal + sensor housings
Light, rigid and balanced.
Payload enclosures
Machined or formed sheet metal.
Sheet metal chassis
Ground stations, racks + carts.
Counter-UAS hardware
Sensor and effector mounts.
Additive parts
Fast-turn prototypes and fit checks.
Wire harnesses
Built to print, shipped with the parts.

Specifications

What a typical UAS job looks like.

Tolerances
±0.005" standard. ±0.001" on critical features.
Materials
6061 + 7075 aluminum, titanium, stainless, PEEK, nylon.
Processes
CNC milling + turning, sheet metal, additive, harness assembly.
Sourcing
Domestic vendors. Country of origin documented.
Documentation
Material certs + inspection records. FAI on request.
Quote review
Within 24 hours.

Before it’s built

Drone programs scale fast, and parts designed for a prototype don’t always survive a production lot. Before the quote goes out we check which features drive cost at volume, where weight can come out without losing stiffness, when a part should move from additive to machined, and whether every vendor in the chain meets your sourcing rules.

UAS + counter-UAS questions

Yes. UAS work goes to US vendors in our network, and we document where every part was made. DoD sourcing rules for drone components are phasing in through 2027, so send your contract’s sourcing clauses with the RFQ. We confirm every vendor in the chain meets them before we quote.

Yes. Precision Expedited is ITAR registered, and controlled work goes only to vetted, ITAR-registered domestic shops. Drawings and models are handled under NIST 800-171 compliant controls from RFQ to delivery.

Yes. Many UAS programs start with additive parts or a short machined lot, then scale. At quote we flag the features that get expensive at volume and line up shops with capacity for the next step. The same project manager carries the program through.

±0.005″ is standard, and shops in our network hold ±0.001″ on critical features. Tighten only what controls fit and function, and our engineers will flag tolerance risks during drawing review.

Yes. Harnesses are built to print and coordinated with the machined and fabricated parts, so the whole build ships as one program with one contact.

A STEP file and 2D print, material and finish, quantities and timing, and any sourcing or documentation requirements such as domestic content, country of origin, ITAR or FAI. Missing something? Send what you have and we’ll ask for the rest.

What makes us different

DFM review before anything runs.

Every drawing reviewed before sourcing. Rework in Inconel costs ten times what it costs in aluminum.

One contact. Full accountability.

One PM from first drawing review through final delivery. No handoffs. No surprises.

Parts inspected before shipment.

Full traceability on every part. Chain of custody from raw stock through outgoing inspection.

The right shop, not the cheapest quote.

Every supplier qualified against AS9100 requirements. Machinists selected for experience in hard material.